Nice Choice Sep 06, 2016

The radiators went together very easily with the connections provided to the heating pex and there were no leaks. very easy to bleed. they provide much more heat than I was getting from my old wall convectors and seem to retain the heat a long time after the boiler is off. Not hard to hang either as long as you separate the hanger prongs in increments of 1/2 inch. Also, my wife was pleasantly surprised by the appearance

Great Stuff Sep 19, 2016

I have used this product before. I would not do a shower using any other product. You spend a lot of time and $ doing a new shower, you should do it right. With this, I know everything is sloped properly, the products fit together and it will be waterproof. We used the shower for a few weeks while tile was on its way last time as the shower is watertight, even without tile.

Quietcool Whole House Fan Jul 27, 2016

The QuietCool fan is awesome. We put it in our upstairs master bedroom and run it at night. It keeps the room very cool, almost as good as having the A/C on but waaaaay cheeper. Easy to install and very quiet when running. Great product. Would definitely buy it again.

Crown Boiler Awr038 - 32k Btu - 83.0% Afue - Hot Water Propane Boiler - Chimney Vent Review Aug 15, 2016

Installed this boiler in June 2012 - Very good documentation - Very good response from customer service when I had a question about the controls. Checked on higher efficiency rated boilers but could not justify the much higher price. Until you make up the increase in price with the savings in fuel the unit would be 8 - 10 years old. By then you would probably have maintenance problems and just check the prices on parts for the higher efficiency boilers (parts prices are very high compared... more

Energy Efficient, High Quality Product Oct 26, 2016

I installed this unit about a month ago to heat/cool our 3rd floor loft (finished attic) and it has been working flawlessly so far. It is energy efficient and was straightforward to install using the instructions provided and the appropriate tools (torque wrench, vacuum pump in addition to standard tools). I did purchase a genuine Mitsubishi lineset (MLS143812T-15) elsewhere and found that the torque value of 25-30 ft-lb specified for the 3/8" flare connection was too much and it... more