I Am Hopeful Dec 12, 2016

My first outdoor condenser was installed by a diamond dealer. It quit working three weeks after installation. i contacted e comfort and initiated a warranty claim with chris. Within 10 days i was shipped a new unit. it has worked flawlessly for the past three weeks. I am hopeful it continues to provide the wonderful comfort that i expect for my 1200 sq. Ft. Shop for a long time. why it quit? i do not fully know, but i would still highly recommend one of these units for heating. air... more

Fantech Vhr - 159 Cfm - Heat Recovery Ventilator (hrv) - Top Ports - 6" Duct - Recirculation Review Sep 15, 2016

Great for high humidity pet room ventilation. I bought this unit to improve the air quality in my pet room that contains a 600 gallon aquarium and 200 more gallons in the sump bringing the total volume up to 800 gallons. Needless to say humidity was a problem in this 14' x 14' room. My room has a split ducted a/c unit set to 84 degrees and did have a dehumidifier. These would work together to control the temp and humidity in the room but was using a lot of power to do so. Problem was much... more

Saved A Lot Of Money Oct 26, 2016

AC unit of 8 years died during heat spell and contractors where quoting very high prices to replace. Having some mechanical ability I decided to purchase and install a new unit myself. eComfort guided me through the whole system and the new unit was shipped to Calif. in just a few days. Had new unit installed in two days and had a licensed AC Tech do my start-up. I saved almost $6000 dollars. New project will be a whole house fan system which they also sell.

Warmwire Heated Floor May 28, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more

Happy Aug 23, 2016

Replaced an 80k BTU unit with this one. Install was a breeze even considering the old unit was a floor mount and this one hangs on the wall. My HVAC guy showed up just as I was completing the wiring and it took him about 30 minutes to program it and run through a cycle. It's fast! I took a half-hour long shower, and by the time I'd dried, dressed and went to the utility room it was on standby........