Warmwire Heated Floor Jun 07, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more

Nice Choice Oct 26, 2016

The radiators went together very easily with the connections provided to the heating pex and there were no leaks. very easy to bleed. they provide much more heat than I was getting from my old wall convectors and seem to retain the heat a long time after the boiler is off. Not hard to hang either as long as you separate the hanger prongs in increments of 1/2 inch. Also, my wife was pleasantly surprised by the appearance

Saved A Lot Of Money Nov 01, 2016

AC unit of 8 years died during heat spell and contractors where quoting very high prices to replace. Having some mechanical ability I decided to purchase and install a new unit myself. eComfort guided me through the whole system and the new unit was shipped to Calif. in just a few days. Had new unit installed in two days and had a licensed AC Tech do my start-up. I saved almost $6000 dollars. New project will be a whole house fan system which they also sell.

Crown Boiler Awr280 - 234k Btu - 83.3% Afue - Hot Water Propane Boiler - Chimney Vent Review Jun 15, 2016

Installed this boiler in June 2012 - Very good documentation - Very good response from customer service when I had a question about the controls. Checked on higher efficiency rated boilers but could not justify the much higher price. Until you make up the increase in price with the savings in fuel the unit would be 8 - 10 years old. By then you would probably have maintenance problems and just check the prices on parts for the higher efficiency boilers (parts prices are very high compared... more

Happy Aug 23, 2016

Replaced an 80k BTU unit with this one. Install was a breeze even considering the old unit was a floor mount and this one hangs on the wall. My HVAC guy showed up just as I was completing the wiring and it took him about 30 minutes to program it and run through a cycle. It's fast! I took a half-hour long shower, and by the time I'd dried, dressed and went to the utility room it was on standby........