Well Made Heater Oct 20, 2016

This heater was easy to install, it is made of high quality metal. Nice to have power connections on both sides of the heater and ample amount of heat.

Warmwire Heated Floor Jun 03, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more

Nice Unit, Fan Adjustment Instructions Are Vague Sep 14, 2016

Purchased this HRV to replace our 22-year old Mayaire unit. Didn't realize until the HRV arrived that it must hang for installation. My original unit sat on a table I built for it. So it took quite a while to find the right spot to have good access for straps, and not interfere with existing duct lines for old unit. The unit is much quieter than my original one, which is a plus. The only issue I had with the new unit is that the instructions for adjusting fan speeds are pretty vague. It took... more

Great Fan - Makes A Big Difference Aug 04, 2016

I live in central California with evaporative cooling. I'm using this fan to vent out the hot air. The QuietCool replaced a simple department store unit and the difference is amazing. With much higher air flow, the whole house stays cooler. It's not a quiet fan, but it's 10 times quieter than any other fan with anywhere near the same air flow. I only wish I had found out about this unit years ago!

Love Is Fantech Aug 25, 2016

I used this inline fan to hook up to my vent hood in my kitchen. Even though this product was assembled in America, the motor was made in Germany and you certainly can't go wrong with German technology. I also brought LD10 silencer to attach directly to the fan and placed the silencer between the vent hood and the fan. I also purchased the FC10 clamp to hold the silencer and fan in place. I find the clamp itself was not good enough to hold fan and the silencer. To give me a piece of mind,... more