Great For Bedroom Addition Nov 03, 2016

Our new Mitsubishi makes our bedroom an oasis. This mini-split is ultra quiet and takes the humidity out of the air in short order. My husband (who is a Handy Andy) did all the preliminary installation with no problems, we chose to mount the outside unit on a stand made for mini splits rather than to our cement board siding. A licensed HVAC man came in to do the final vac of the lines to get it fired up, and we could then validate the warranty also. We find setting it at 68 degrees works... more

Steam Gas Boiler Best Investment Jul 12, 2016

Everything about this Boiler was right on. Everything was labeled correctly, And the instruction booklet made the piping allot easier than I was thinking.

Great! Jul 23, 2016

Had this boiler for 2 winters now in MA. First winter was hard. This last one less so. Great product. Made is USA. Cast iron. Will last forever my plumber tells me. Still 84% efficient. Doesn't need yearly maintenance like the higher efficient junk out there. That high efficient junk also requires a power vent that is super loud. Consider that too in your purchase. This Burnham is very quiet. No power vent. I use an old school dial thermostat and set it at 67. When I get my heating bill... more

Saved A Lot Of Money Nov 01, 2016

AC unit of 8 years died during heat spell and contractors where quoting very high prices to replace. Having some mechanical ability I decided to purchase and install a new unit myself. eComfort guided me through the whole system and the new unit was shipped to Calif. in just a few days. Had new unit installed in two days and had a licensed AC Tech do my start-up. I saved almost $6000 dollars. New project will be a whole house fan system which they also sell.

This Is My 3rd Weil-mclain Boiler Jun 23, 2016

- this one is working great now after I fixed it out of the box. It would have been nice to have had fire up immediate right after install. But no it would not lite. It was not getting gas to the pilot light due to the supply line from the gas cock was to tight from being stretched to far to left of the gas cock thus by moving it over a row in the burner line up the tension of the gas supply to the pilot opened enough to allow the pilot to lite. It's now up and running for nearly 3... more